Posted on January 11, 2019


Enable 4 Select Enable or Disable using the or key. You should use a grid cleaner attaching it to the printer and pull out the charger unit as instructed below. Plug the power cord into the printer and turn the printer on. The factory setting is Rewrap paper that is not in use. These items will not appear unless the printer is installed with the applicable option unit.

Uploader: Zoloshura
Date Added: 20 May 2006
File Size: 54.78 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 99528
Price: Free* [*Free Regsitration Required]

The new setting will be enabled thereafter. Chapter 3 Maintenance This chapter explains how to replace the toner container, waste toner box, and how to care for your printer.

Support & Download | KYOCERA Document Solutions

In the Fs-3820nn mode and Nibble high mode, these signals are bi-directional. Item Specification Weight Cassette: To ensure the proper moisture content, it is important to store the paper in a controlled environment. Check program files and application software. Replace the old waste toner box with the new one which is included in the toner kit.

In this menu, you can also set the type and pitch for Courier and Letter Gothic. Remove the tapes from the sorter.

See Also  F4185 DRIVER

This is affected by the smoothness, size, and moisture content of the paper, and the way in which the paper is cut. There are three general grades of paper: Since the composition and quality of special paper vary considerably, special paper is more likely than white bond paper to give trouble during printing.

With the label side down, thoroughly shake the toner container in the direction of the arrows ten times or more.

Close paper transfer unit. Copies of the document are printed using the stored data.

See Maintenance Messages on page Print quality is not good. Close duplexer rear cover Open the option duplexer rear cover, then close tightly.

Support & Download

You obtain no rights other than those granted you under this license. On 6 7 8 Select On or Off using the or key. A Microdrive Hard Disk Top sheet white bond paper Adhesive Carrier sheet Adhesive label paper must be entirely covered by its top sheet, with no spaces between the individual labels. About formatting a new Microdrive.

Download Center

To print remaining copies of a job held in the printer: When this setting is On, switch it to Off on the Operator Panel. Feeding label paper from a paper cassette may cause printer failure.


The table also indicates whether each signal is incoming or outgoing with respect to ffs-3820n printer. To see gs-3820n data contained in the CompactFlash card at once, print a list of data names as explained on pagePrinting a List of Data Names.

Fogging is a gray background effect. Note 3 Put the old toner container in the plastic bag supplied with the toner kit and dispose of it. Close sorter rear cover Open the sorter rear cover, then close tightly.

Kyocera Mita FSN KX driver free download for windows – FUJITSU – LIFEBOOK S

By using option paper feeders in conjunction with the printer paper cassette, which can also hold approximately sheets of paper, up to approximately 2, sheets of paper can be fed continuously. Specified file not on disk. Fs-38820n paper has a natural tendency to curl in one direction. The page printer can use the following types of special paper. Printing a list is also available for a font card.